FAQs

Soldering Points For ESCs
If you have broken connectors/pins, you may need to know where the soldering points are. Here are the soldering points of some ESCs.  13A 4in1 ESC ...
Wed, 26 Feb, 2020 at 4:09 PM
What target should I set when updating firmware on Flight Controller
Wed, 26 Feb, 2020 at 5:03 PM
How to get data from ESC on FC
To get data from ESC on FC, pls refer to the steps below: 1)Open the serial port option in betaflight. 2)Open the configuration where to use BLHeli32 sett...
Wed, 26 Feb, 2020 at 5:06 PM
I can't switch channel on VTX
Pls make sure that both the remote control and the drone are powered on. 1. The remote control throttle is in the middle position; 2. PITCH highest and RO...
Thu, 27 Feb, 2020 at 10:39 AM
What are the parameter settings for AMASS XT60 / XT30 CURRENT SENSOR on Betaflight
Please refer to the settings below
Thu, 27 Feb, 2020 at 10:38 AM
How to connect TBS Crossfire Nano to FD F4 Mini FC (FD435,FD445 Stack)
Wed, 11 Mar, 2020 at 11:03 AM
My Flight Controller Cannot recognize UART Ports. The light is red on the board.
Try to flash your firmware to the latest version if you are using Betaflight 4.1 or later version, with the following settings: Remember to clic...
Sat, 14 Mar, 2020 at 2:38 PM
How to bind transmitter to receiver
Binding steps: 1.  First turn on ‘’bind‘’ in remotre controller. 2. Then holds the button of receiver to power on. 3. When the red and green lights on re...
Sat, 11 Apr, 2020 at 11:27 AM
VTX table for Zeus nano 350mW VTX
VTX table for Zeus nano 350mW VTX
Sat, 7 Nov, 2020 at 3:37 PM
VTX table for Zeus 800mW VTX
VTX table for Zeus 800mW VTX
Sat, 7 Nov, 2020 at 3:38 PM